rev. 01.18.06 DS650-3 1of 4 embedded power for business-critical continuity DS650-3 650 watts 12v distributed power system special features ? active power factor correction ? en61000-3-2 harmonic compliance ? active ac inrush control ? 1u x 2u form factor ? 11.76w / in 3 (ds650) ? +12vdc output ? +3.3vdc stand-by (5v standby - consult factory) ? no minimum load required ? hot plug operation ? n + 1 redundant ? internal or'ing fets ? active current sharing (10 - 100% load) ? built-in cooling fans (40mm x 28mm) ?i 2 c communication interface bus ? eerpom for fru data ? red/green bi-color led status ? internal fan speed control ? fan fail tach output signal ? intel, ssi std. logic timing ? intel, ssi std. fru data format ? one year warranty distributed power bulk front-end total output power: 650 watts +12vdc main output +3.3vdc stand-by output wide range input voltage: 90 - 264vac electrical specifications safety input input range 90-264 vac (wide range) frequency 47-53 hz, single phase ac inrush current 55a maximum inrush current efficiency >82% typical at full load, high line conducted emi fcc subpart j en55022 class b radiated emi fcc subpart j en55022 class b power factor 0.99 typical leakage current 1.40ma @ 240vac hold up time 20ms minimum output main dc voltage +12v @ 52.5a stand-by +3.3vsb @ 6a (5v @ 4a available) adjustment range factory set, no pot adjustments regulation +12vdc; +5%/-5% +3.3vsb; +5%/-5% over current +12vdc; latches off if overcurrent lasts over 1 second, otherwise it is auto recovery (see table 1 next page) +3.3vsb, 9a max (hiccup mode) over voltage +12vdc; 13.2 - 14.4vdc +3.3vsb; 3.76 - 4.30vdc under voltage +12vdc; 9 - 10.8v (latch off) turn-on delay 2 second max, 5 - 50ms, monotonic rise +12voutput rise time 5 - 50ms, monotonic rise ul/cul 60950 (ul recognized) nemko+ cb report en60950 en60950 ce mark china ccc
rev. 01.18.06 DS650-3 2of 4 embedded power for business-critical continuity ordering information o o u u t t p p u u t t n n o o m m i i n n a a l l o o u u t t p p u u t t v v o o l l t t a a g g e e s s e e t t p p o o i i n n t t s s e e t t p p o o i i n n t t t t o o l l e e r r a a n n c c e e t t o o t t a a l l r r e e g g u u l l a a t t i i o o n n m m i i n n i i m m u u m m c c u u r r r r e e n n t t m m a a x x i i m m u u m m c c u u r r r r e e n n t t o o u u t t p p u u t t r r i i p p p p l l e e p p / / p p o o v v e e r r c c u u r r r r e e n n t t DS650-3 12.0vdc 3.3vsb 0.2% 1% 5% 5% 13.2a 0a 52.5a 6.0a 480mv 60mv 57.5a - 78.5a* 7a max *over current latches off if overcurrent lasts over 1 seconds, otherwise it is auto recovery. *for 5vsb, consult marketing. logic control ps_seated ttl logic low if power supply is seated into system con- nector. this is a short pin. a logic high if the psu is removed pwr good active ttl low when output is within regulation limits. ac ok a high logic level if the input voltage is within allowable limits. a ttl logic high level, and a 5ms early warning signal before 12.0v dc output loss of regulation. temp ok a ttl logic high, when operating within allowable temperature range. ps_inhibit/ps_kill this signal is connected to a short pin on the psu when left open power supply operation will be inhibited. when the power supply is inserted into the system, this pin will be pull low by the system and turn the power sup- ply on only after all other power supply pins have seated. operating temperature: -10 to 50c ; 50% power derating at 70c storage temperature: -40c to +85c altitude, operating 10,000ft. electromagnetic susceptibility / input transients: -en61000-3-2, -3-3 -en61000-4-2, 4.3, 4-4, -4-5, 4-11 level -en55024:1998 rohs & lead-free compliant (no tantalum caps.) humidity: 20 to 90% rh, non-condensing shock and vibration specificatons complies with astec std. specifications, q3205 mtbf (demonstrated) 500k hrs at full load, 40c environmental specifications
rev. 01.18.06 DS650-3 3of 4 embedded power for business-critical continuity .315" (8.0) 7.48" (190.0) 3.09" (78.5) .767" (19.5) (3x) 3.09" (78.5) (15.5) (40.5) (65.5) 3.09" (78.5) .649 (16.5) 1.58" (40.2) clip compressed airflow direction bi-color led 11.0" .02" (279.4 0.5) 10.85" .03" (275.5 0.7) .354" (9.0) .256" (6.5) .236" (6.0) 1.57" .02" (39.9 0.5) .142" .02" (3.6 0.5) 3.20" .02" (81.3) 0.5 1.60" (40.7) .275" (7.0) (2x) 3.30" .03" (83.8 0.7) .897" .02 (22.8 0.6) .638" .02" (16.2 0.6) see note 3 full r model ds850-3 astec condition led status +3v3sb-on; +12vout-off; a a c c p p r r e e s s e e n n t t blinking green +3v3sb-on, +12vout-on solid green + + 1 1 2 2 v v _ _ o o c c p p , , + + 1 1 2 2 v v _ _ u u v v p p , , + + 4 4 8 8 o o v v p p blinking red f f a a n n _ _ f f a a u u l l t t , , o o t t p p , , 3 3 v v 3 3 o o c c p p / / u u v v p p solid red mechanical drawing
rev. 01.18.06 DS650-3 4of 4 emerson network power and the emerson network power logo are trademarks and service marks of emerson electric co. ?2006 emerson electric co. embedded power for business-critical continuity emerson network power. the global leader in enabling business-critical continuity. emersonnetworkpower. com ac power connectivity dc power embedded power inbound power integrated cabinet solutions outside plant precision cooling site monitoring and services astec power 5810 van allen way carlsbad, ca 92008 usa telephone: +1 760 930 4600 facsimile: +1 760 930 0698 technical support: +1 888 41 astec or +1 407 241 2752 waterfront business park merry hill, dudley west midlands, dy5 1lx united kingdom telephone: +44 (0) 1384 842 211 facsimile: +44 (0) 1384 843 355 units 2111-2116, level 21 tower 1, metroplaza 223, hing fong road kwai fong, new territories hong kong telephone: +852 2437 9662 facsimile: +852 2402 4426 for global contact, visit: www.astecpower.com technicalsupport@astec.com while every precaution has been taken to ensure accuracy and completeness in this literature, astec power assumes no responsibility, and disclaims all liability for damages resulting from use of this information or for any errors or omissions. printed in us a dc output connector pinout assignment p p i i n n s s i i g g n n a a l l n n a a m m e e pb 1 +12v return pb 2 +12v return pb 3 +12v return pb 4 +12v pb 5 +12v pb 6 +12v a1 ps_on a2 +12v rmt sense return a3 temp_ok a4 ps_seated ( power supply seated) a5 +3v3 stand-by a6 +3v3sb return b1 ac_ok (ac input present) b2 +12v rmt sense b3 +12v current share b4 ps_inhibit b5 +3v3 stand-by b6 +3v3sb return c1 sda (i2c data signal) c2 scl (i2c clock signal) c3 power good c4 fan fail (fan fail signal) c5 +3v3 stand-by c6 +3v3sb return d1 a0 (i2c address bit 0 signal) d2 a1 (i2c address bit 1 signal) d3 s_int (alarm) d4 +3v3 stand-by rmt sense d5 +3v3 stand-by d6 +3v3sb return p p 1 1 - - p p o o w w e e r r s s u u p p p p l l y y s s i i d d e e 1. fci power blade 51721 series 51721-10002406aa 2. molex power connector sd-87667 series 87667-7002 m m a a t t i i n n g g c c o o n n n n e e c c t t o o r r ( ( s s y y s s t t e e m m s s i i d d e e ) ) 1.fci power blade 51741-10002406cc strait pins 2.fci power blade 51761-10002406aa right angle d1 d2 d3 d4 d5 d6 pb1 pb2 pb3 pb4 pb5 pb6 c1 c2 c3 c4 c5 c6 b1 b2 b3 b4 b5 b6 a1 a2 a3 a4 a5 a6 male connector as viewed from the rear of the supply:
|
